Kmc-controls MCP-1130 Series Bedienungsanleitung PDF herunterladen

Installation Guide

3” Pneumatic Damper Actuator

MCP-1030, 1130 Series

Mounting

Post Mounted - Typically used for internal duct mounting.

1. Connect the damper’s blade clip or drive arm with the clevis pin and cotter pin.

2. Position the damper for its “normal” position.

3. Mount the offset bracket to either the damper frame or the duct.

4. Check that the linkage will not bind as the shaft extends and retracts.

Right Angle Mounted - Typically used for external duct mounting.

1. Slide the crankarm over the damper shaft.

2. Determine whether the damper shaft must rotate Clockwise (CW) or Counter Clockwise (CCW).

3. Locate the half-circle cutouts on the outside corners of the bracket.

4. Place the appropriate half circle cutout over (for clockwise rotation), or under (for counter clockwise

rotation) the damper shaft.

5. Loosely mount the actuator externally on the duct or air handling unit.

6. Leave sufficient room for adjusting and servicing the unit.

7. Position the damper for its “normal” position.

8. Tighten the crankarm set screws.

9. Check that the linkage will not bind as the shaft extends and retracts.

10. Firmly anchor the bracket to the duct. The actuator assembly is positioned for 90° rotation.

1 2

Inhaltsverzeichnis

Seite 1 - Installation Guide

Installation Guide3” Pneumatic Damper ActuatorMCP-1030, 1130 SeriesMountingPost Mounted - Typically used for internal duct mounting.1. Connect the dam

Seite 2 - Maintenance

Connections♦ Use 1/4" (6 mm) O.D. polyethlyene tubing.♦ Use only clean, dry control air. No attempt should bemade to use any other medium.NOTE: I

Verwandte Modelle: MCP-1030 Series

Kommentare zu diesen Handbüchern

Keine Kommentare

Kmc-controls MCP-1130 Series Bedienungsanleitung

Stöbern Sie online oder laden Sie Bedienungsanleitung nach Sensoren Kmc-controls MCP-1130 Series herunter. KMC Controls MCP-1130 Series User Manual Benutzerhandbuch

Inhaltsverzeichnis

Verwandte Modelle: MCP-1030 Series

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Sensoren Kmc-controls MCP-1130 Series